Now with Support for Plug and Play Sensors (No Soldering!) Sensors Purchased Separately from Seeedstudio
 |
 |
 |
 |
 |
 |
* Some soldering is required for the Maxbotix LV EZ-1 Proximity Sensor as in this diagram, solder points close-up
**** This Version of the Kit is No Longer Availabile ****
The Magic Mirror hardware is open source so you can build the hardware yourself and just buy the software. The Magic Mirror Kit does make the job much easier though and is now available assembled from Seeedstudio. The sensors are purchased separately.
| Item | Price | Where to Buy |
| Just the Magic Mirror Software | $49 | diymagicmirror.com |
| Magic Mirror Kit Assembled, Software, and Seeeduino (Arduino Equivalent) | $119 | seeedstudio.com |
Assembled Kit Includes:
- Assembled Magic Mirror Shield with Seeeduino Atmega328 (pre-loaded with Firmata software)
- Magic Mirror Software Registration Code
- Power Header Cable
- 5mm Blue LED
- 2 Cat5e Cables (T568B wiring)
- Mini USB Cable
- 10K Potentiometer Lug Pins (to be externally mounted)
- Hook Up Wire (24 Gauge)
You Supply:
- The PC
- Monitor
- Picture Frame (Optional)
- Two-Way Mirror (Optional)
- Sensors Specific to your Installation
- X-10 Modules (Optional)
Purchase the assembled kit directly from Seeedstudio.
How to Connect the Sensors (4:17 min)
Magic Mirror Software Setup Video Tutorial (7:35 min)
If building your own circuit, the software may be purchased stand alone below. A fully assembled Sensor Hub with case and built in Breathalyzer is also available below.
The Magic Mirror kit can be purchased from Seeedstudio. If you already have an Arduino and can build the circuit yourself, you can also purchase just the software.
A software registration key will be e-mailed to you after your Paypal payment has been received.